If your Motion Sensor Gen 2 is not detecting motion, it’s likely the result of the placement of the Sensor itself.

We recommend mounting the Motion Sensor Gen 2 in the corner of your room. For optimal performance, the sensor must be mounted 6 feet from the ground. This ensures proper coverage throughout the room. The Motion Sensor Gen 2 has a 90-degree field of view, and can see outwards 35 feet. You can also mount the Motion Sensor Gen 2 to a flat wall. If opting for this, note that the Sensor will only capture the 90 degrees out from its center, meaning that 45 degrees on either side will not be captured.

Diagram of Motion Sensor placements - A sensor placed in corner with uninterrupted field of view vs. a sensor placed in the middle of the wall with two 45 degree blind spots.

If you are placing the Motion Sensor Gen 2 on a flat surface rather than mounting it, we recommend having it as close to the edge of the surface as possible.

Once you have made any changes to your Motion Sensor Gen 2, you can then begin to test the sensor.

Use your Keypad to place the system into Test Mode

Tap the Menu Button
Enter your PIN
Use the arrow keys to scroll until Test Mode is highlighted

Arm your system to AWAY mode and leave the room during the exit delay

Pro-tip, bring your Keypad with you for the next steps

After the exit delay has counted down and the system is armed, wait 2-3 minutes and then enter the room

You should begin to hear your system count down for the entry delay. You can now disarm your system using your Keypad.

If you did not hear the entry delay trigger and waited 2-3 minutes before re-entering the room, please contact support for additional troubleshooting.

App Features

Popular

Featured Articles

How To Find or Change Your Safe Word

How to Set Up Arming Reminders

How can I see my Payment and Billing History?

What is the Difference Between Home Mode and Away Mode?

How do I Activate Monitoring?

Updating Your Emergency Monitoring Contacts

When is my bill due, and can I change the due date?

How many devices can I connect to the Base Station?

SimpliSafe® System and Wi-Fi Requirements

App Error: Internet Not Found

My privacy shutter isn’t responding correctly.

Setting Up A New PIN

How To Find or Change Your Master PIN

What is Practice Mode?

Key Fob Not Responding To Button Presses

Scheduled Arming for Your SimpliSafe® System

SimpliCam Wired Indoor Camera LED Status Light Colours

What are the Wi-Fi upload speed requirements?

How to Replace Motion Sensor Gen 2 Battery

My Video Doorbell Pro Won't Connect to Wi-Fi During Setup

Where Can I Submit a Product or Feature Request?

How to Reset the Video Doorbell Pro

Camera Motion Detection by System Arming State

How To Set Up or Delete A Custom PIN

Biometric Authentication for SimpliSafe® Accounts

Entry Sensor Alert Voice Prompt

Where to Download the SimpliSafe® App

How to activate app control

Motion Sensor Gen 2 Not Detecting Motion

How to Replace Batteries in SimpliSafe® Devices

Where can I purchase additional yard signs, sensors, and other accessories?

Video Doorbell Pro Motion Detection

Video Doorbell Pro Installation Guide

How to Improve Upload Speed?

How To Replace Water Sensor Battery

2-Step Verification for SimpliSafe® Accounts

Base Station LED Status Light Colours

Entry Sensor Offline

Outdoor Security Camera Series 2 Flashing Yellow During Setup

My Entry Sensor Will Not Pair to My System